micropolis 1334 hard disk drive specifications, Micropolis 1334 Hard Disk Drive Specifications, Jumpers,
micropolis 1334 hard disk drive repair, Micropolis 1334 Hard Disk Drive Repair,
micropolis 1334 hard disk drive specs, Micropolis 1334 Hard Disk Drive Specs,
micropolis 1334 hard disk drive repair, Micropolis 1334 Hard Disk Drive Repair Micropolis 1334

micropolis 1334 picture.
micropolis 1334 picture.
micropolis 1334 picture.

Micropolis 1334 Specifications
Model Capacity Size Height Bus Type Int.Type
Micropolis 1334 53MB 5.25" FHT MFM ST506

Size 5-1/4 Inch
Interface ST-506/412
Interface Type  
Encoding Method MFM 
Formatted Capacity 53.4
Disks 4
Heads 6
Cylinders 1024
Sectors 17
Buffer Size N/A
Average Seek 28 msec
Single Track 6 msec
Rotation Speed/Avg. Latency 3600 rpm +/- 0.5%
Transfer Rate to / from. media 5 Mbits/sec
Transfer Rate to / from buffer N/A
Tracks Per Inch (TPI)  
Bits Per Inch (BPI)  
Dimensions 8.0"L x 5.75"W x 3.25"H
Weight 5.75 lbs.

  +12V +/-5% +5V +/-5% Power
Spin up 3.9A (max)    
Read / Write 2.0A avg 0.9A avg  
Typical     29 Watts

Drive Addressing and Interface Termination

DS1, DS2, DS3, DS4 Drive Select Jumpers
  The Drive Select jumper locations are identified as DS1, DS2, 
  DS3, and DS4. Only one Drive Select jumper is installed on a 
  drive. The drives are shipped with the jumper installed at DS1.
  For every drive in a PC/AT installation, move the jumper from DS1
  to DS2 (the special twisted interface cable that is generally
  used takes care of assigning a unique address to each drive).
  Some other systems may require that each drive be jumpered to a
  unique address (i.e., different DS numbers).

RN1 Interface Terminator
  The Interface Terminator factory installed at RN1 provides proper
  termination for the interface lines. When daisy-chaining multiple
  1334 drives, leave the terminator in the last physical drive on
  the daisy chain cable; remove the terminator from each of the
  other drives. In most PC/AT installations, the C: drive is
  actually at the end of the cable and should retain the

W1 Write Fault Latch
  W1 is the Write Fault Latch. If W1 is present and the drive
  encounters a write fault, all writing to the drive is inhibited
  until after the drive has been de-selected. If W1 is absent,
  fault conditions are not latched. Drives are shipped with a
  jumper installed at W1; remove it for PC/AT installations.

W2 is always installed.

W7 is never installed.

W8 is always installed.

All manufacturer's Names, Logos and trademarks are the properties of the respective manufacturer.

HOME Micropolis Drive Specs All Hard Drives TOP

Check our Media Store for all your Floppy Disk and Tape Supplies.

Contact us

Copyright © 1997 - 2011 Erv Fleckstein ( M. Farris & Associates ). All Rights Reserved.