Data Technology DTC-5160CRH Controller
Default settings are in Bold or are selected by a 
.
W1: ROM BIOS Size
W2: ROM Address
|
(3/4) |
(2/5) |
(1/6) |
| C800 |
On |
Off |
Off |
| CA00 |
On |
Off |
On |
| D800 |
On |
On |
Off |
| F400 |
On |
On |
On |
| Disable |
Off |
--- |
--- |
(Default is C800.)
W3: DACK Select
W4: DREQ Select
W5: IRQ Select
W6: Software Readable Jumpers: (Not used by the Standard BIOS.)
W7: Port Address Select
The DTC-5160 is set up using the DOS Debug command at offset ":5" (ie: g=c800:5).
Boot from a DOS diskette... You will see the message:
*Controller Board Configuration*
Hard Disk 1: Configuration parameters not found.
To install the configuration parameters, run Debug, and follow the instructions. (A copy of the program is contained in the "paper" version of TheRef(tm)).
| DTC-5160x | DTC-5160xl |
Home | Feedback |